Pulsa Series 880
FLOW
Up to 102 gph (386 lph)
PRESSURE
1,800 psi (124 bar)
Overview
Specifications
Brochure
Tech Sheets
IOMS
Overview
Pulsa Series 880 is a hydraulic diaphragm metering pump, engineered for precise dosing and long-term dependability, delivering superior value. It offers a diverse range of fluid handling solutions with unique wet end designs consisting of HYDRAtube®, or flat diaphragm types, each available in a variety of wet-end materials. It complies with the API 675 standard for use in oil & gas, petrochemical, chemical processing, power generation, and water & wastewater treatment industries.
- Hydraulic diagnostic window provides observation of oil condition and proper pump operation saving time troubleshooting
- Externally adjustable bypass valve protects the pump from system over-pressurization to quickly adapt to unexpected changes to process conditions
- Push-to-purge button allows for on-demand removal of air from pump hydraulics to avoid wasting energy from inefficient pump operation
- Hydraulically balanced diaphragm for long life and reduced service cost
- Hydraulic management system assures consistent performance
- Internal hydraulic bypass valve for pump protection against system upset
- Epoxy coating resists corrosion from atmospheric contaminants
- Easy maintenance with KOPkit® (Keep on Pumping kit)
- 4-Bolt tie-bar valve assembly for service without disturbing system piping
- Full motion stroke length yields 0-100% flow adjustment
- Linear flow predictability over a 10:1 turndown
- 1% dosing accuracy
- Pulsafeeder stands by their equipment with a 5 year gear train warranty
Specifications
Steady State Accuracy +/-1.0% of set point
Repeatability +/-1.0% of rated capacity
Linearity +/-1.0% of rated capacity over 10:1 turndown
Full Motion Stroke length control mechanism
Stroke Length Capacity Control Either manual or electronic (PULSAMatic Stroke Length Controller)
Fluid Temperatures Up to 250°F (121°C) and with ATEX 174°F (79°C)
Minimum Fluid Temperature -10°F (-23°C) and with ATEX to -4°F (-20°C)
Viscosity Up to 1,000 cPs
Net Positive Inlet Pressure (NPIP) Required 5 psi (0.31 bar)
Standards compliance API-675, CE, ATEX
Pump Head Materials 316SSL, GF-PTFE, PVC
Diaphragm Types Flat, Tube, Cone: Standard flat single PTFE, Hypalon or Viton
Pump Body Cast Aluminum
Pump Base Steel or Stainless Steel
Valve Types Ball type is standard Disc Type for slurry solutions or at high flow rates
Connection Types NPT, Raised face flange
Motor Frames 56C, 143/145TC, IEC71B14, 80B14
Modular Configurations Simplex, Duplex, Triplex, and Multiplex up to 17 pumps
Brochure
Tech Sheets
IOMS
Hypalon® and Viton® are registered trademark of E.I. DuPont Company.
